Audi Q3 P0405:  EGR Sensor “A” → Circuit Low

 

P0405 is a generic OBDII trouble code.  It deals with the signal coming from the EGR system.  Since it is a generic code, it has the same meaning for the Audi Q3 as it would any other vehicle.  

The EGR system allows a certain amount of the Q3’s exhaust to re-enter the combustion chamber, which helps lower the emissions coming from your Q3’s exhaust.  When the EGR system has an issue, usually the only thing you’ll notice is the check engine light.  

P0405 Audi Q3

 

P0405 Symptoms:  Audi Q3

Since the EGR valve is part of the emissions system, there really isn’t going to be much in the way of symptoms.  Usually, all you’ll see is the check engine light.

 

P0405 Causes and Solutions:  Audi Q3

Almost all of the time, P0405 is going to be caused by wiring issues or a bad EGR Valve.  We’ll go over both of them in better detail directly below.

Audi Q3 P0405 Diagnosis

Bad EGR Valve

If you happen to have a good scan tool, you can actually use it to command the EGR valve to open.  If the EGR valve refuses to open it would be time to check the wiring harness for voltage at the plug that goes into the EGR.  If the voltage is OK, then replacing the EGR valve may be a good idea.  There’s plenty on testing this wiring in the next section.

Carbon, junk, and even ice can cause the EGR circuit to stick.  The most common cause of P0405 is the EGR valve.  But, blindly replacing it without testing it can be a waste of money.

If it does end up being the EGR valve, they are pretty affordable.  

 

Wiring Issues

A great place to start diagnosing P0405 in your Q3 is going to be the wiring harness.  Being that the wiring harness that goes to the EGR valve is by the hot engine it has a higher propensity to fail than other wiring in the vehicle, it is often the problem.

Find the wiring harness where it starts at the EGR valve.  Does the plugin have any visible signs of damage?  If it doesn’t, go ahead and inspect the wiring harness for any damage.  You’ll be looking for frayed wiring.  Look close at any place that it may come into contact with the engine, frame, or anywhere that it takes a sharp turn.

To check the voltage at the harness, you’ll need a volt meter.  Check the voltage at the reference circuit.  If it’s at 5 volts, but the EGR Valve won’t open, that’s a pretty good indication that the EGR is bad. 

If you get 12 volts or 0 volts, that would be an indication of a wiring problem.  Here’s a great writeup on diagnosing your wiring issues from AA1Car.com

 

Conclusion

Most of the time, when P0405 is thrown, it’ll be the EGR valve that is the cause.  It is still a good idea to test it and the wiring before buying a new one though. 

If there is anything that you would like to add, please leave a comment below.  Good luck diagnosing your Q3!