Mercury Villager P0158: Oxygen Sensor High Voltage (Bank 2 -Sensor 2)

P0158 Mercury Villager


P0158 is an OBDII code that occurs in many vehicles, including the Mercury Villager. The code is triggered when:

  • The voltage at the O2 sensor remains above threshold for 20 seconds or more
  • Voltage to the sensor is to high (wiring problem, think short)
  • Bad O2 sensor itself

There are also some less likely problems that can cause P0158. We’ll discuss them below.


Bank 2 is the side of the engine with the second cylinder in the firing order.

Sensor 2 is downstream of the catalytic converter.  


Here’s a pretty helpful video from on diagnosing the code:



Mercury Villager P0158 Symptoms

Typically, the only symptom of P0158 is going to be the check engine light. In some cases, there can be other symptoms as well. These symptoms include:

  • Rough running engine
  • Smelly exhaust
  • Service light on
  • Poor MPG

P0158 is almost never a breakdown risk (Chrysler vehicles being the exception). But, like anything that causes the service engine soon light to come on it is a good idea to have it fixed as soon as possible. 


Mercury Villager P0158 Causes

Here are the most common issues that cause the P0158 code in the Mercury Villager. They are presented in order (somewhat) of most to least likely to cause the problem.

Mercury Villager P0158 Diagnosis

  • Bad Oxygen Sensor– The O2 sensor itself is one of the most likely reasons that P0158 is triggering your service engine soon light. Although it is a temptation to replace it right away, it wouldn’t hurt to check out the wiring harness around it beforehand. See directly below. They are relatively affordable at Autozone or Amazon.
  • Wiring Harness Issues– The wiring that goes to the front and rear oxygen sensors is very susceptible to damage. This is due to the fact that O2 sensors are under the chassis where they are subject to punishment from road debris, and they are subjected to a lot of exhaust heat. The downstream sensor is especially susceptible to this problem Here’s how to find a short in the wiring harness (Youtube).
  • Damage to the Terminal– The terminal that the oxygen sensor connects to (the plug) is also relatively susceptible to damage. You’ll want to make sure that there is voltage going to it. There’s more on that directly below.
  • Wrong O2 Sensor– If you are getting P0158 after having recently replaced your Oxygen sensor, it may be that the replacement is wrong or bad.


Villager P0158 Diagnosis

It is possible to diagnose the P0158 with a multimeter. If you use the multimeter, you’ll know whether or not the voltage coming to and from the oxygen sensor is within spec, this can help you determine if it’s your Villager’s O2 sensor, or wiring harness that’s the issue.

If you don’t have access to a multimeter, it certainly wouldn’t hurt to check the wiring to between the fuse box and the Oxygen sensor first. If it ends up being a wiring issue, it’ll save you money over buying an unnecessary O2 sensor.

You can also use a voltage test light to determine whether or not the oxygen sensor is getting any voltage at all (they’re about $5 at Walmart).

If it’s not getting any voltage, attach the test light to the harness plug and shake the wiring a little bit. If the light comes on, even for a second, you know that you have a short circuit causing the P0158 trouble code.



Good luck finding whatever caused P0158 in your Mercury Villager. If you have anything that you would like to add, please feel free to leave a comment below.