There are quite a few reasons why your Chrysler 300 could be idling rough. An internal combustion engine needs air, fuel, and spark in order to achieve ignition. When one or more of these variables is off it can lead to a rough idling condition. Most of the time the culprit is going to be the ignition system, although there are a myriad of other causes. We’ll cover the most common causes of rough idle below.
Chrysler 300 Rough Idle Causes
Hopefully, the check engine light is on. It can tell you a lot about what is going on with your 300. You can either go to the local parts store and ask them to scan the vehicle for you, or you can do this yourself. Most of them will do that as a courtesy (obviously they want to sell the parts). Alternatively, code scanners are pretty affordable. Having one of your own can save you a ton of time.
Once you get the trouble codes you can use that information to determine whether it’s an O2 sensor, spark plugs, coil packs, etc that may be causing the trouble. Here are the most common problems that would cause a Chrysler 300 to idle rough:
Here are the main components of the ignition system, as well as what would cause them to make your 300 idle roughly.
- Spark Plugs– One of the absolute most common causes (if not the most common reason that your 300 may be misfiring) is the spark plugs. Although most modern vehicles use iridium spark plugs, they still need to be changed at the manufacturers recommended interval. This page has a great chart for you to compare your spark plug condition to new plugs.
- Ignition Coil Packs– Nearly all model years and engines use coil packs. These packs are fired by the engines computer at exactly the right time to provide the optimal ignition timing. If a coil pack goes bad, it’ll cause a misfire and rough idle condition. Really, your 300 will be running rougher at any RPM, but a misfire will be most pronounced at idle.
- Spark Plug Wires– While not every model and engine combination of vehicles today comes with spark plug wires (a lot are now coil on plug), if your 300 happens to have them, they can go bad and cause a rough idle. Here’s a great video on how to diagnose bad plug wires with a multimeter.
If you have reason to suspect that your 300’s air filter has not been changed in a very long time, or if you have recently been driving in tough conditions, it may be worth taking a look at it.
It could be so clogged that there is not enough air getting through for quality idle conditions. In fact, if your check engine light isn’t on at all, checking out the air filter would be a great place to start. It’s readily accessible, often the problem, and super cheap and easy to replace.
The oxygen sensors that are equipped in your Chrysler 300 are responsible for monitoring the exhaust to help the ECU determine the correct air/fuel mixture.
Of all the sensors equipped in your vehicle, the O2 sensors may have it the hardest. They deal with super hot exhaust that can cover them in deposits that can leave them ineffective. The heat of the exhaust can also bake the wiring going to/from them over time.
If an oxygen sensor goes bad, it can make your 300 run too lean (or rich). A super lean running engine will often idle rough.
The fuel injection systems job is to atomize the fuel into fine mist. If a fuel injector has an issue with this process, it will either let too much or too little fuel into the combustion chamber relative to the amount of air. There are many reasons why a fuel injector may go bad, as well as different symptoms relative to how they went bad. For more, check out Chrysler 300 bad fuel injector symptoms.
There are many reasons that your Chrysler 300 may be idling rough. We tried to lay out the most common ones above. Try and go off of the OBDII codes if you were lucky enough to have them. If there is anything else that you would like to add, please leave a comment below. Good luck!!